Search results
Results From The WOW.Com Content Network
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m ). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd ...
Because of the identity property of multiplication, multiplying any quantity (physical or not) by the dimensionless 1 does not change that quantity. Once this and the conversion factor for seconds per hour have been multiplied by the original fraction to cancel out the units mile and hour, 10 miles per hour converts to 4.4704 metres per second.
The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
The units of cubic length (the cubic inch, cubic foot, cubic mile, etc.) are the same in the imperial and US customary systems, but they differ in their specific units of volume (the bushel, gallon, fluid ounce, etc.). The US customary system has one set of units for fluids and another set for dry goods. The imperial system has only one set ...
The unit of substance in the FPS system is the pound-mole (lb-mol) = 273.16 × 1024. Until the SI decided to adopt the gram-mole, the mole was directly derived from the mass unit as (mass unit)/ (atomic mass unit). The unit (lbf⋅s 2 /ft)-mol also appears in a former definition of the atmosphere.
The Compositio redefined the yard, foot, inch, and barleycorn to 10 ⁄ 11 of their previous value. However, it retained the Anglo-Saxon rod of 15 x 11 ⁄ 10 feet (5.03 metres) and the acre of 4 × 40 square rods. Thus, the rod went from 5 old yards to 5 + 1 ⁄ 2 new yards, or 15 old feet to 16 + 1 ⁄ 2 new feet. The furlong went from 600 ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.