Search results
Results From The WOW.Com Content Network
1. Remove the label spool from inside of the printer and separate the spool disk from the spindle. 2. Hold the spool spindle (A) in your left hand and place the label roll on the spindle so that the labels feed from underneath and the left edge of the label roll is firmly against the side of the spool. 3.
How to use DYMO Label Software v.8? DYMO Label Software v.8, Windows, MacOS, how to use, manual, user guide, editing labels, adding barcode, adding QR code, importing data, DYMO Label address book, 508 compliance, foreign characters, unicode, DHC
Printer and label selection. Select an installed printer at the bottom of the screen, on the right of the side bar. Select the label in the left side bar by going to the Labels tab > Label Types. Select the label category from the dropdown list next to 'Show'. Find the label size you are using on the list below.
2. Remove the tape cassette. 3. Pull 1 inch (2,5 cm) of tape out of the cassette. 4. Insert the cassette again without cutting the advanced tape. 5. If there is no improvement, please try using a different tape cartridge. LabelManager, feed issue, no print, no feed, tape jam, motor stall, error, display, DHC.
The steps on how to maintain your label maker can be found HERE. 1. Turn off the LabelManager. 2. Open the cartridge door to access the tape compartment. 3. Remove the tape cassette. 4. Slowly begin closing the tape compartment door while keeping a close eye on the print head.
2. Remove the tape cassette. 3. Pull 1 inch (2,5 cm) of tape out of the cassette. 4. Insert the cassette again without cutting the advanced tape. 5. If there is no improvement, please try using a different tape cartridge. LetraTag, feed issue, no print, no feed, tape jam error, 100H, 100T, stuck, jammed, stuck, DHC.
Make sure it is connected directly without USB hubs or docks. 4. Plug the power cable back into the printer and turn the printer on. 5. If the labels are not detected again, close DYMO Connect and run it as administrator. 5. Insert a different roll of labels into the printer and feed them through.
If the ribbon is not tight then tighten it by turning the black spool in the cassette clockwise until the ink ribbon is tight against the label tape. The ink ribbon in the tape cassette may also be broken or severed. Replace the tape cassette if that is the case. If the ink ribbon is intact, insert it back into the printer firmly or align it ...
1. Remove both the Power and the USB cable from the back of your LabelWriter. 2. Remove any labels inserted into your printer (use the black release lever located on the left-hand side). 3. Navigate to Control Panel\Hardware and Sound\Devices and Printers. 4. Right-click on LabelWriter and select See what’s printing.
1. Make sure the power is on. If you just pressed the power button, wait 30 seconds for the printer to fully boot up. 2. Using a pointed object, not metal, press and hold the RESET button on the back of the printer for at least five seconds. 3. After five seconds, release the RESET button to initiate printer reset.