Money A2Z Web Search

Search results

1. Results From The WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A drain-waste-vent system (or DWV) is the combination of pipes and plumbing fittings that captures sewage and greywater within a structure and routes it toward a water treatment system. It includes venting to the exterior environment to prevent a vacuum from forming and impeding fixtures such as sinks, showers, and toilets from draining freely ...

3. Trap primer - Wikipedia

   en.wikipedia.org/wiki/Trap_primer

   Trap primer. A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps. The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Non-return or check valves allow the free flow of a fluid in one direction but prevent its flow in a reverse direction. They are often seen in drainage or sewage systems but may also be used in pressurized systems. Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve ...

5. Check valve - Wikipedia

   en.wikipedia.org/wiki/Check_valve

   A swing check valve (or tilting disc check valve) is a check valve in which the disc, the movable part to block the flow, swings on a hinge or trunnion, either onto the seat to block reverse flow or off the seat to allow forward flow. The seat opening cross-section may be perpendicular to the centerline between the two ports or at an angle.

6. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   Trap (plumbing) Water seal in drain pipe under a sink. Water enters at right, fills the trap, and continues left. Inverted siphoning occurs below the line "A". In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials ...

7. Flush toilet - Wikipedia

   en.wikipedia.org/wiki/Flush_toilet

   A typical flush toilet is a fixed, vitreous ceramic bowl (also known as a pan) which is connected to a drain. After use, the bowl is emptied and cleaned by the rapid flow of water into the bowl. This flush may flow from a dedicated tank (cistern), a high-pressure water pipe controlled by a flush valve, or by manually pouring water into the bowl.

8. Drain (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Drain_(plumbing)

   Drain (plumbing) A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed. In most systems, the drain is for discharge of waste fluids, such as the drain in a sink in ...

9. Plumbing drawing - Wikipedia

   en.wikipedia.org/wiki/Plumbing_drawing

   t. e. A plumbing drawing, a type of technical drawing, shows the system of piping for fresh water going into the building and waste going out, both solid and liquid. It also includes fuel gas drawings. Mainly plumbing drawing consist of water supply system drawings, drainage system drawings, irrigation system drawings, storm water system drawings.