Search results
Results From The WOW.Com Content Network
The use of the vernier scale is shown on a vernier caliper which measures the internal and the external diameters of an object. The vernier scale is constructed so that it is spaced at a constant fraction of the fixed main scale. So for a vernier with a constant of 0.1, each mark on the vernier is spaced 9/10 of those on the main scale.
Degree precision versus length decimal places decimal degrees DMS Object that can be unambiguously recognized at this scale N/S or E/W at equator E/W at 23N/S E/W at 45N/S E/W at 67N/S 0 1.0: 1° 00′ 0″ country or large region: 111 km: 102 km: 78.7 km: 43.5 km 1 0.1: 0° 06′ 0″ large city or district: 11.1 km: 10.2 km: 7.87 km: 4.35 km ...
1:36: 8.467 mm Popular scale for period ship plans — 1 inch = 3 feet. 1:35: 8.709 mm: Military models: The most popular scale for military vehicles and figures. Used heavily in models of armoured vehicles. It was originally conceived by Tamiya for convenience of fitting motorised parts and batteries. Corresponds well with 54mm figures. 1:34: ...
[1] The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
A common adjustment value in firearm sights is 1 cm at 100 meters which equals 10 mm / 100 m = 1 / 10 mrad. The true definition of a milliradian is based on a unit circle with a radius of one and an arc divided into 1,000 mrad per radian, hence 2,000 π or approximately 6,283.185 milliradians in one turn , and rifle scope ...
A ruler with two linear scales: the metric and imperial.It includes shorter minor graduations and longer major graduations. A graduation is a marking used to indicate points on a visual scale, which can be present on a container, a measuring device, or the axes of a line plot, usually one of many along a line or curve, each in the form of short line segments perpendicular to the line or curve.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
One edge is divided into tenths of an inch, and the subsequent ones are directly marked for twentieths, thirtieths, fortieths, fiftieths, and finally sixtieths of an inch. Referred to as 1:10, 1:20, 1:30,1:40, 1:50 or 1:60 scale. [2] Typically in civil engineering applications, 1:10 (1″=10′) is used exclusively for detail drawings.