Search results
Results From The WOW.Com Content Network
It is intended primarily to save cost in low-bandwidth human interface devices (HID) such as keyboards, mice, and joysticks. Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0.
USB device communication is based on pipes (logical channels). A pipe is a connection from the host controller to a logical entity within a device, called an endpoint. Because pipes correspond to endpoints, the terms are sometimes used interchangeably. Each USB device can have up to 32 endpoints (16 in and 16 out), though it is rare to have so ...
USB-C plug. USB-C (SuperSpeed USB 5Gbps) receptacle on an MSI laptop. USB-C, or USB Type-C, is a 24-pin connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, e.g., to connect to monitors or external drives. It can also provide and receive power, to power, e.g., a laptop or a mobile phone.
A USB cable, by definition, has a plug on each end—one A (or C) and one B (or C)—and the corresponding receptacle is usually on a computer or electronic device. The mini and micro formats may connect to an AB receptacle, which accepts either an A or a B plug, that plug determining the behavior of the receptacle.
USB Attached SCSI. USB Attached SCSI ( UAS) or USB Attached SCSI Protocol ( UASP) is a computer protocol used to move data to and from USB storage devices such as hard drives (HDDs), solid-state drives (SSDs), and thumb drives. UAS depends on the USB protocol, and uses the standard SCSI command set.
Duplex mismatch. On an Ethernet connection, a duplex mismatch is a condition where two connected devices operate in different duplex modes, that is, one operates in half duplex while the other one operates in full duplex. The effect of a duplex mismatch is a link that operates inefficiently. Duplex mismatch may be caused by manually setting two ...
Common flash devices such as USB flash drives and memory cards provide only a block-level interface, or flash translation layer (FTL), which writes to a different cell each time to wear-level the device. This prevents incremental writing within a block; however, it does help the device from being prematurely worn out by intensive write patterns.
WebUSB is a JavaScript application programming interface (API) specification [1] for securely providing access to USB devices from web applications. [2] It was published by the Web Platform Incubator Community Group. As of July 2021, it is in Draft Community status, and is supported [3] by Google Chrome, Microsoft Edge, QQ, Opera, and Samsung ...