Search results
Results From The WOW.Com Content Network
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
If using the metric unit meters for distance and the imperial unit inches for target size, one has to multiply by a factor of 25.4, since one inch is defined as 25.4 millimeters. distance in meters = target in inches angle in mrad × 25.4 {\displaystyle {\text{distance in meters}}={\frac {\text{target in inches}}{\text{angle in mrad}}}\times 25.4}
The R-value (in K ⋅ m 2/ W) is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [ 2] flow of heat, in the context of construction. [ 3]. R-value is the temperature difference per unit of heat flux needed to sustain one unit of heat flux between the ...
The recent formula used by the Brannock device assumes a foot length of 2 barleycorns less than the length of the last; thus, men's size 1 is equivalent to a last's length of 8 + 1 ⁄ 3 in (21.17 cm) and foot's length of 7 + 2 ⁄ 3 in (19.47 cm), and children's size 1 is equivalent to 4 + 1 ⁄ 4 in (10.8 cm) last's length and 3 + 7 ⁄ 12 in ...
1⁄12 ft 3. The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. It equals the volume of a board that is one-foot (305 mm) in length, one-foot (305 mm) in width, and one-inch (25.4 mm) in thickness. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT, or BF.