Search results
Results From The WOW.Com Content Network
A lift-check valve is a check valve in which the disc, sometimes called a lift, can be lifted up off its seat by higher pressure of inlet or upstream fluid to allow flow to the outlet or downstream side. A guide keeps motion of the disc on a vertical line, so the valve can later reseat properly.
The maximum working pressure of high-pressure ball valves can be up to 15,000 psi (1,000 bar). High-pressure ball valves are often used in hydraulic systems, so they are also known as hydraulic ball valves. Ball valves in sizes up to 2 inches (51 mm) generally come in a single piece, two or three-piece designs. One-piece ball valves are almost ...
A blowdown valve ( BDV) is a type of shutdown valve designed to depressurize a pressure vessel by directing vapour to a flare, vent or blowdown stack in an emergency. BDVs fail-safe to the open position upon failure of the control system. [ 1] The type of valve, type of actuation and performance measurement are similar to an ESD valve.
Pinch valve, for slurry flow regulation and control. Piston valve, for regulating fluids that carry solids in suspension. Piston valve (steam engine) Plug valve, slim valve for on–off control but with some pressure drop. Solenoid valve, an electrically actuated valve for hydraulic or pneumatic fluid control.
The filaments ricochet off the periodic structures, deflecting increasingly sharply before being rerouted around the 'islands' and mixing. A Tesla valve, called a valvular conduit by its inventor, is a fixed-geometry passive check valve. It allows a fluid to flow preferentially in one direction, without moving parts.
A double check valve or double check assembly (DCA) is a backflow prevention device designed to protect water supplies from contamination. [ 1] It is different from the two-way check valves (sometimes erroneously referred to as double check valves) used in air brake systems on heavy trucks which select from the highest pressure source.
Air (or other gas) pressure is the power source for pneumatic valve actuators. [1] They are used on linear or quarter-turn valves. Air pressure acts on a piston or bellows diaphragm creating linear force on a valve stem. Alternatively, a quarter-turn vane-type actuator produces torque to provide rotary motion to operate a quarter-turn valve.
The stroke of each piston is caused by an eccentric drive shaft or an external eccentric tappet (e.g., stroke ring). When filling the workspace of the pumping pistons from "inside" (e.g., over a hollow shaft) it is called an inside impinged (but outside braced) radial piston pump (picture 1). If the workspace is filled from "outside" it's ...