Search results
Results From The WOW.Com Content Network
The initial design of the GM 10.5" 14-bolt differential spanned from 1973 to 1984, remaining unaltered until 1986. This iteration featured brake drums secured by wheel studs and utilized a smaller diameter pinion bearing compared to the subsequent design. The second design, in production since 1986, introduced notable improvements.
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60. It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and ...
Dana 70. The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing and is visually similar to the Dana 60.
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
Dana 80. The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and ...
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6. Cadillac HT4100/4.5/4.9 L V8.
A powered de Dion suspension uses universal joints on both ends of its driveshafts (at the wheel hubs and at the differential ), and a solid tubular beam to hold the opposite wheels in parallel. Unlike an anti-roll bar, a de Dion tube is not directly connected to the chassis, and is not intended to flex. In suspension geometry it is a beam axle ...
The Camaro Performance V8 concept is a black Camaro SS with Chevrolet Performance ZL1 rear differential kit, 5.1-ratio short-throw shifter, shock tower brace with white Camaro graphic, Camaro 1LE suspension kit, Camaro ZL1 brake conversion kit, concept dual-mode exhaust system, Camaro ZL1 rockers and rear lower diffuser, Camaro Dusk front ...