Search results
Results From The WOW.Com Content Network
Cain and Abel (often abbreviated to Cain) was a password recovery tool for Microsoft Windows. It could recover many kinds of passwords using methods such as network packet sniffing, cracking various password hashes by using methods such as dictionary attacks, brute force and cryptanalysis attacks. [ 1] Cryptanalysis attacks were done via ...
Wireshark is very similar to tcpdump, but has a graphical front-end and integrated sorting and filtering options.. Wireshark lets the user put network interface controllers into promiscuous mode (if supported by the network interface controller), so they can see all the traffic visible on that interface including unicast traffic not sent to that network interface controller's MAC address.
The WPS push button (center, blue) on a wireless router showing the symbol defined by the Wi-Fi Alliance for this function. Wi-Fi Protected Setup ( WPS) originally, Wi-Fi Simple Config, is a network security standard to create a secure wireless home network . Created by Cisco and introduced in 2006, the purpose of the protocol is to allow home ...
Kismet is a network detector, packet sniffer, and intrusion detection system for 802.11 wireless LANs. Kismet will work with any wireless card which supports raw monitoring mode, and can sniff 802.11a, 802.11b, 802.11g, and 802.11n traffic. The program runs under Linux, FreeBSD, NetBSD, OpenBSD, and macOS. The client can also run on Microsoft ...
Wi-Fi Protected Access ( WPA ), Wi-Fi Protected Access 2 ( WPA2 ), and Wi-Fi Protected Access 3 ( WPA3) are the three security certification programs developed after 2000 by the Wi-Fi Alliance to secure wireless computer networks. The Alliance defined these in response to serious weaknesses researchers had found in the previous system, Wired ...
Gargoyle (router firmware) Gargoyle is a free OpenWrt -based Linux distribution for a range of wireless routers based on Broadcom, Atheros, MediaTek and others chipsets, [2] [3] Asus Routers, Netgear, Linksys and TP-Link routers. Among notable features is the ability to limit and monitor bandwidth and set bandwidth caps per specific IP address.
The packet number is a 48-bit number stored across 6 octets. The PN codes are the first two and last four octets of the CCMP header and are incremented for each subsequent packet. Between the PN codes are a reserved octet and a Key ID octet. The Key ID octet contains the Ext IV (bit 5), Key ID (bits 6–7), and a reserved subfield (bits 0–4).
The recommended solution to WEP security problems is to switch to WPA2. WPA was an intermediate solution for hardware that could not support WPA2. Both WPA and WPA2 are much more secure than WEP. [21] To add support for WPA or WPA2, some old Wi-Fi access points might need to be replaced or have their firmware upgraded.