Search results
Results From The WOW.Com Content Network
A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. [ 1 ] Check valves are two-port valves, meaning they have two openings in the body, one for fluid to enter and the other for fluid to leave.
A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process. In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on ...
In power engineering, a single-line diagram ( SLD ), also sometimes called one-line diagram, is a simplest symbolic representation of an electric power system. [ 1][ 2] A single line in the diagram typically corresponds to more than one physical conductor: in a direct current system the line includes the supply and return paths, in a three ...
Hydraulic analogy. Analogy between a hydraulic circuit (left) and an electronic circuit (right). Electronic-hydraulic analogies are the representation of electronic circuits by hydraulic circuits. Since electric current is invisible and the processes in play in electronics are often difficult to demonstrate, the various electronic components ...
A double check valve or double check assembly (DCA) is a backflow prevention device designed to protect water supplies from contamination. [ 1] It is different from the two-way check valves (sometimes erroneously referred to as double check valves) used in air brake systems on heavy trucks which select from the highest pressure source.
The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [ 1]
The system is called reverse acting if it is necessary to apply negative corrective action. For instance, if the valve in the flow loop was 100–0% valve opening for 0–100% control output – meaning that the controller action has to be reversed. Some process control schemes and final control elements require this reverse action.
Shuttle valve. Shuttle valve symbol. Shuttle valve action principle cross section. A shuttle valve is a type of valve which allows fluid to flow through it from one of two sources. Generally a shuttle valve is used in pneumatic systems, although sometimes it will be found in hydraulic systems. [ 1]