Search results
Results From The WOW.Com Content Network
The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.
It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot . In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit.
American Wire Gauge ( AWG) is a logarithmic stepped standardized wire gauge system used since 1857, predominantly in North America, for the diameters of round, solid, nonferrous, electrically conducting wire. Dimensions of the wires are given in ASTM standard B 258. [ 1] The cross-sectional area of each gauge is an important factor for ...
Of particular interest was the rood which was 15 North German feet in length, the North German foot being equivalent to 335 mm (13.2 inches). [3]: 50 Craftsmen, on the other hand used a shorter Roman foot. The standard Troy pound, destroyed in a fire in 1834. Standardization of weights and measures was a recurring issue for monarchs.
A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.
The furlong–firkin–fortnight ( FFF) system is a humorous system of units based on unusual or impractical measurements. The length unit of the system is the furlong, the mass unit is the mass of a firkin of water, and the time unit is the fortnight. [ 1][ 2] Like the SI or metre–kilogram–second systems, there are derived units for ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...