Search results
Results From The WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
In science and engineering, the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities, e.g. mole fraction or mass fraction. Since these fractions are quantity-per-quantity measures, they are pure numbers with no associated units of measurement. Commonly used are parts-per-million ( ppm ...
57 mm 2.244 inch Ordnance BL 10-pounder Mountain gun: Mountain gun 69.8 mm 2.75 inch 12-pounder (multiple types) Light field gun 76.2 mm 3 inch Ordnance QF 13-pounder: Light field gun 76.2 mm 3 inch 15- pounder (multiple types) Field gun 76.2 mm 3 inch Ordnance QF 17- pounder: Anti-tank gun 76.2 mm 3 inch Ordnance QF 18- pounder: Field gun 83.8 ...
However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge shells with their lower pressure rating of 11,500 psi (79 MPa), began to approach the performance of the 3 + 1 ⁄ 2-inch (89 mm) 10-gauge shells with a ...
British Standard Pipe ( BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external ( male) thread with an internal (female) thread. It has been adopted as standard in plumbing and pipe fitting, except in North America, where NPT and ...
B shot is 0.170 in (4.3 mm), and sizes go up in 0.01 in (0.25 mm) increments for BB and BBB sizes. In metric measurement, it is easy to remember that #5 shot is 3 mm; each number up or down represents a 0.25 mm change in diameter, so e.g. #7 shot is 2.5 mm.
The "4 bore rifle" caliber's technical data was reissued by C.I.P in 1993. The latest revision of the homologation papers were released by May 15, 2002. [8] This standard and its variations are reflected in obsolete 4 gauge shotgun cartridges and their repurposing as modern 1-inch (25.4 mm) bore flare cartridges. [9] [10] [11]
Weight per wafer 100 mm2 (10 mm) Die per wafer 1-inch (25 mm) 1960 2-inch (51 mm) 275 μm: 1969 9 3-inch (76 mm) 375 μm 1972 29 4-inch (100 mm) 525 μm 1976 10 grams [18] 56 4.9 inch (125 mm) 625 μm 1981 95 150 mm (5.9 inch, usually referred to as "6 inch") 675 μm 1983 144 200 mm (7.9 inch, usually referred to as "8 inch") 725 μm.