Money A2Z Web Search

  1. Ads

    related to: gm code 15 2 1427 4 pin adapter

Search results

  1. Results From The WOW.Com Content Network
  2. General Motors Local Area Network - Wikipedia

    en.wikipedia.org/wiki/General_Motors_Local_Area...

    Transport-layer services include the transmission of multi-CAN-frame messages based on the ISO 15765-2 multi-frame messaging scheme. It was developed and is used primarily by General Motors for in-vehicle communication and diagnostics. GM's Tech2 uses the CANdi (Controller Area Network diagnostic interface) adapter to communicate over GMLAN.

  3. ALDL - Wikipedia

    en.wikipedia.org/wiki/ALDL

    ALDL. ALDL 12 pins connector - front view. Assembly Line Diagnostic Link, Assembly Line Data Link, or ALDL is a proprietary on-board diagnostics system developed by General Motors before the standardization of OBD-2. It was previously called Assembly Line Communications Link or ALCL. The two terms are used interchangeably.

  4. Data link connector - Wikipedia

    en.wikipedia.org/wiki/Data_link_connector

    The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the fuse ...

  5. List of GM bellhousing patterns - Wikipedia

    en.wikipedia.org/wiki/List_of_GM_bellhousing...

    The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

  6. SAE J1772 - Wikipedia

    en.wikipedia.org/wiki/SAE_J1772

    SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler". [1]

  7. 25-pair color code - Wikipedia

    en.wikipedia.org/wiki/25-pair_color_code

    A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.

  1. Ads

    related to: gm code 15 2 1427 4 pin adapter