Search results
Results From The WOW.Com Content Network
A heavy duty version of Aluminium Powerglide was offered for passenger cars equipped with the 409 cubic inch V8 engine, and Chevrolet light trucks using a 1.76:1 reduction planetary gear set, instead of the usual 1.82:1. With a 3.31 axle, Car and Driver magazine noted a full-throttle up shift speed of 76 mph (122 km/h) to direct with the 409 ...
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6. Cadillac HT4100/4.5/4.9 L V8.
The initial design of the GM 10.5" 14-bolt differential spanned from 1973 to 1984, remaining unaltered until 1986. This iteration featured brake drums secured by wheel studs and utilized a smaller diameter pinion bearing compared to the subsequent design. The second design, in production since 1986, introduced notable improvements.
Dimensions. Dry weight. 550 to 650 lb (250 to 290 kg) [citation needed] The Pontiac V8 engine is a family of overhead valve 90° V8 engines manufactured by the Pontiac Division of General Motors Corporation between 1955 and 1981. The engines feature a cast-iron block and head and two valves per cylinder.
The 366 cu in (6.0 L) big-block V-8 gasoline engine was used in Chevrolet medium duty trucks and school buses. It had a bore and a stroke of 3.935 in × 3.76 in (99.9 mm × 95.5 mm). This engine was made from the 1960s until 2004.The 366 used 4 rings on the pistons, as it was designed from the very beginning as a truck engine.
FWD/AWD. 2015. 2015–2019 Opel Karl. 2015–2019 Vauxhall Viva. 2016–2022 Chevrolet Spark. 2016 – 2018 Holden Spark. 2019–2022 VinFast Fadil *. 2021–present Chevrolet Trax. The successor to the Gamma II platform, in accordance with GM's renaming of most of their platforms in "_ _ XX" format circa 2015.
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60. It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and ...
Getrag F23 transmission. The F23 is a five-speed manual transmission manufactured by Getrag in Italy. [citation needed] It is designed for transverse engine applications, primarily by General Motors. It can handle torque inputs of over 230 newton-metres (170 lbf⋅ft ). The F23 has one roll pin, two gearsets on each of three parallel shafts ...