Search results
Results From The WOW.Com Content Network
Cliffjumper, a redeco of Bumblebee, was to be released as a 3-inch non-transforming figure in the Transformers: Titanium line in early 2007. This version of Cliffjumper does carry a gun. Titanium 6 inch War Within Cliffjumper (unreleased) A prototype of a 6-inch-tall War Within Bumblebee/Cliffjumper figure was seen at a Hasbro factor tour in 2007.
A 1996 study of flaccid length found a mean of 8.8 cm (3.5 in) when measured by staff. [3] Flaccid penis length can sometimes be a poor predictor of erect length. An adult penis that is abnormally small but otherwise normally formed is referred to in medicine as a micropenis, with the cutoff usually being defined as around 3 inches (7.6 cm).
Human penis. In human anatomy, the penis ( / ˈpiːnɪs /; pl.: penises or penes; from the Latin pēnis, initially "tail" [ 1]) is an external male sex organ ( intromittent organ) that serves as a passage for excretion of urine and ejaculation of semen. The main parts are the root, body, the epithelium of the penis including the shaft skin, and ...
The first commonly available increase in tape length resulted from a reduction in backing thickness from 1.5 to 1.0 mil (38 to 25 μm) resulting in a total thickness reduction from 42 to 35 μm (1.7 to 1.4 mils), which allowed 3,600 ft (1,100 m), 1,800 ft (550 m), and 900 ft (270 m) tapes to fit on ten-and-a-half-, seven-, and five-inch reels respectively.
Sheet resistance is the resistance of a square piece of a thin material with contacts made to two opposite sides of the square. [ 1] It is usually a measurement of electrical resistance of thin films that are uniform in thickness. It is commonly used to characterize materials made by semiconductor doping, metal deposition, resistive paste ...
Stiffness. Extension of a coil spring, caused by an axial force, Stiffness is the extent to which an object resists deformation in response to an applied force. [ 1] The complementary concept is flexibility or pliability: the more flexible an object is, the less stiff it is. [ 2]
As an example, a 10 mm (0.394 in) shaft made of 303 stainless steel will form a tight fit with allowance of 3–10 μm (0.00012–0.00039 in). A slip fit can be formed when the bore diameter is 12–20 μm (0.00047–0.00079 in) wider than the rod; or, if the rod is made 12–20 μm under the given bore diameter.
Ultimate tensile strength (also called UTS, tensile strength, TS, ultimate strength or in notation) [ 1] is the maximum stress that a material can withstand while being stretched or pulled before breaking. In brittle materials, the ultimate tensile strength is close to the yield point, whereas in ductile materials, the ultimate tensile strength ...