Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
An electric arc between two nails. An arc flash is the light and heat produced as part of an arc fault (sometimes referred to as an electrical flashover ), a type of electrical explosion or discharge that results from a connection through air to ground or another voltage phase in an electrical system. Arc flash is distinctly different from the ...
ATEX Directive 2014/34/EU was published on 29 March 2014, by the European Parliament. It refers to the harmonization of the laws of the Member States relating to equipment and protective systems intended for use in potentially explosive atmospheres. Regarding ATEX 99/92/EC Directive, the requirement is that Employers must classify areas where ...
TEFC motor. A Totally Enclosed, Fan-Cooled ( TEFC) electric motor is a type of industrial electric motor with an enclosure that does not permit outside air to freely circulate through the interior of the motor. An external fan blows outside air over the frame of the motor to cool it. This motor is arguably the most commonly used motor in ...
Intrinsic safety ( IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost ...
The aftermath of a boiler explosion at Strømmen station near Oslo, Norway, 22 December 1888. One locomotive was thrown into the air and landed on the roof of another; the crews of both escaped without injury A boiler explosion is a catastrophic failure of a boiler. There are two types of boiler explosions. One type is a failure of the pressure parts of the steam and water sides. There can be ...
The National Electrical Code ( NEC ), or NFPA 70, is a regionally adoptable standard for the safe installation of electrical wiring and equipment in the United States. It is part of the National Fire Code series published by the National Fire Protection Association (NFPA), a private trade association. [1]
The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical enclosures ...