Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
The aim of Directive 2014/34/EU is to allow the free trade of ‘ATEX’ equipment and protective systems within the EU by removing the need for separate testing and documentation for each member state. The regulations apply to all equipment intended for use in explosive atmospheres, whether electrical or mechanical, including protective ...
Intrinsic safety ( IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost ...
The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical enclosures ...
An electric arc between two nails. An arc flash is the light and heat produced as part of an arc fault (sometimes referred to as an electrical flashover ), a type of electrical explosion or discharge that results from a connection through air to ground or another voltage phase in an electrical system. Arc flash is distinctly different from the ...
The flash point is a descriptive characteristic that is used to distinguish between flammable fuels, such as petrol (also known as gasoline ), and combustible fuels, such as diesel . It is also used to characterize the fire hazards of fuels. Fuels which have a flash point less than 37.8 °C (100.0 °F) are called flammable, whereas fuels having ...
An explosion is a rapid expansion in volume of a given amount of matter associated with an extreme outward release of energy, usually with the generation of high temperatures and release of high-pressure gases. Explosions may also be generated by a slower expansion that would normally not be forceful, but is not allowed to expand, so that when ...
Avoidance makes it impossible for an explosion or deflagration to occur, for instance by means of suppressing the heat and the pressure needed for an explosion using an aluminum mesh structure such as eXess, by means of consistent displacement of the O 2 necessary for an explosion or deflagration to take place, by means of padding gas (f. i. CO 2 or N 2), or, by means of keeping the ...