Search results
Results From The WOW.Com Content Network
Gillham code is a zero-padded 12-bit binary code using a parallel nine- [ 1] to eleven-wire interface, [ 2] the Gillham interface, that is used to transmit uncorrected barometric altitude between an encoding altimeter or analog air data computer and a digital transponder. It is a modified form of a Gray code and is sometimes referred to simply ...
The aviation transponder interrogation modes are the standard formats of pulsed sequences from an interrogating Secondary Surveillance Radar (SSR) or similar Automatic Dependent Surveillance-Broadcast (ADS-B) system. The reply format is usually referred to as a "code" from a transponder, which is used to determine detailed information from a ...
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
0041–0057. Belgium. Assigned for VFR traffic under Flight Information Services (BXL FIC). [citation needed] 0100. Australia. Flights operating at aerodromes (in lieu of codes 1200, 2000 or 3000 when assigned by ATC or noted in the Enroute Supplement). [ 6] 0100–0400.
A low-noise block downconverter ( LNB) is the receiving device mounted on satellite dishes used for satellite TV reception, which collects the radio waves from the dish and converts them to a signal which is sent through a cable to the receiver inside the building. Also called a low-noise block, [ 1][ 2] low-noise converter ( LNC ), or even low ...
A discrete transponder code (often called a squawk code) is assigned by air traffic controllers to identify an aircraft uniquely in a flight information region (FIR). This allows easy identification of aircraft on radar. [6] [7] Codes are made of four octal digits; the dials on a transponder read from zero to seven, inclusive. Four octal digits ...
A communications satellite 's transponder is the series of interconnected units that form a communications channel between the receiving and the transmitting antennas. [ 1] It is mainly used in satellite communication to transfer the received signals. A transponder is typically composed of: an input band-limiting device (an input band-pass ...
The user of the car may not even be aware that the transponder is there, because there are no buttons to press. When a key is inserted into the ignition lock cylinder and turned, the car's computer sends a signal to the transponder. Unless the transponder replies with a valid code, the computer will not allow the engine to be started.