Search results
Results From The WOW.Com Content Network
Decimal degrees ( DD) is a notation for expressing latitude and longitude geographic coordinates as decimal fractions of a degree. DD are used in many geographic information systems (GIS), web mapping applications such as OpenStreetMap, and GPS devices. Decimal degrees are an alternative to using sexagesimal degrees (degrees, minutes, and ...
Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think about them ["two-fifty", "five hundred", "seven-fifty"]. Machinists generally ...
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
Geographic coordinate conversion has applications in cartography, surveying, navigation and geographic information systems . In geodesy, geographic coordinate conversion is defined as translation among different coordinate formats or map projections all referenced to the same geodetic datum. [ 1] A geographic coordinate transformation is a ...
A minute of arc is π 10 800 of a radian . A second of arc, arcsecond (arcsec), or arc second, denoted by the symbol ″, [ 2] is 1 60 of an arcminute, 1 3600 of a degree, [ 1] 1 1 296 000 of a turn, and π 648 000 (about 1 206 264.8) of a radian. These units originated in Babylonian astronomy as ...
Choke (firearms) A choke is a tapered constriction of a firearm barrel at its muzzle end. Chokes are most commonly seen on shotguns, but are also used on some rifles, pistols, or even airguns. [ 1] Notably, some .22 LR match rifles have a constricted bore diameter near the muzzle. [citation needed] Chokes are almost always used with modern ...
50· π. 10. A degree (in full, a degree of arc, arc degree, or arcdegree ), usually denoted by ° (the degree symbol ), is a measurement of a plane angle in which one full rotation is 360 degrees. [ 4] It is not an SI unit —the SI unit of angular measure is the radian —but it is mentioned in the SI brochure as an accepted unit. [ 5]
The general relationship between absorbed dose and equivalent dose can be represented as. H = Q ⋅ D. where H is the equivalent dose, D is the absorbed dose, and Q is a dimensionless quality factor. Thus, for any quantity of D measured in Gy, the numerical value for H measured in Sv may be different.