Money A2Z Web Search

Search results

1. Results From The WOW.Com Content Network

2. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   British Standard Pipe ( BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external ( male) thread with an internal (female) thread. It has been adopted as standard in plumbing and pipe fitting, except in North America, where NPT and ...

3. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Coupling (piping) In piping and plumbing, a coupling (or coupler) is a very short length of pipe or tube, with a socket at one or both ends that allows two pipes or tubes to be joined, welded ( steel ), brazed or soldered ( copper, brass etc.) together. Alternatively it is a short length of pipe with two female National pipe threads (NPT) (in ...

4. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   National pipe taper fuel (NPTF) National Pipe Taper Fuel ( NPTF, also called Dryseal American National Standard Taper Pipe Thread, defined by ASME B1.20.3) is designed to provide a more leak-free seal without the use of PTFE tape (often referred to by the popular brand name "Teflon") or another sealant compound.

5. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower ...

7. RCA connector - Wikipedia

   en.wikipedia.org/wiki/RCA_connector

   Cables should meet the S/PDIF specification as defined by the international standard IEC 60958-3 for assured performance. The male plug has a center pin that is 1 ⁄ 8 inch (3.175 mm) in diameter, and is surrounded by an outer shell that is 1 ⁄ 3 inch (8.47 mm) in diameter.