Search results
Results From The WOW.Com Content Network
Lincoln patented the first lever grease gun to work with a full stroke operation called the Model 1242. This meant that a hand-held grease gun could generate up to 10,000 lbf/in² (70 MPa) of pressure. Operators of the unit could push grease into blocked or "frozen" fittings and the unit allowed for work in confined areas.
The Buffalo Arms bolt in this original M3 is dated January 1944. The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [12] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun, but was cheaper to mass produce and lighter ...
A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed. The aperture may be of a type that ...
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, or Alemite fitting is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
It succeeded at both goals, but it was almost immediately replaced by the cheaper grease gun. Used 20-round or 30-round Thompson magazines. M3 and M3A1 submachine gun: Submachine gun Close-quarters, personal security: Blowback, open bolt United States: General Motors.45 ACP: 91 450 1943 655363 3.61-3.70 30-round magazine. M50 Reising submachine gun
The primary component of the Mk 38 is the 25 mm M242 Bushmaster. It is an externally-powered, chain-driven gun. The Bushmaster uses an electric motor to drive the moving parts for ammunition feeding, loading, firing, extraction, and cartridge ejection. [2] The mass of the M242 on the Mark 38 MGS is 109 kg (240 lb).
Exhausted combination doctrine. The exhausted combination doctrine, also referred to as the doctrine of the Lincoln Engineering case, was the doctrine of U.S. patent law that when an inventor invents a new, unobvious device and seeks to patent not merely the new device but also the combination of the new device with a known, conventional device ...
M50 Reising. The .45 Reising submachine gun was manufactured by Harrington & Richardson (H&R) Arms Company in Worcester, Massachusetts, USA, and was designed and patented by Eugene Reising in 1940. The three versions of the weapon were the Model 50, the folding stock Model 55, and the semiautomatic Model 60 rifle. [4]