Search results
Results From The WOW.Com Content Network
As well as 1 ⁄ 4 in (6.4 mm) tape, studio and multitrack machines use tape widths of 1 ⁄ 2, 1, and 2 inches (12.7, 25.4, and 50.8 mm), and at least one 3 inches (76.2 mm) [citation needed] machine was available for a time. There is also a 35 mm width, but this variety is more similar to the motion picture stock of the same width. It is ...
Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".
National pipe taper fuel (NPTF) National Pipe Taper Fuel ( NPTF, also called Dryseal American National Standard Taper Pipe Thread, defined by ASME B1.20.3) is designed to provide a more leak-free seal without the use of PTFE tape (often referred to by the popular brand name "Teflon") or another sealant compound.
British Standard Pipe ( BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external ( male) thread with an internal (female) thread. It has been adopted as standard in plumbing and pipe fitting, except in North America, where NPT and ...
The 37.5 mm length is not derived by a certain scale ratio. While HO scale is a 1:87 scale (3.5 mm to 1 foot), resulting in a 16.5 mm ( 0.65 in) gauge from real life prototype 1,435 mm ( 4 ft 81⁄2 in) standard gauge standard gauge. Conversely, modeling standard gauge in Lego trains would yield a scaling of (37.5:1435 =) 1:38.3.
Fermière; cut lengthwise and then sliced to desired thickness 1 ⁄ 8 – 1 ⁄ 2 inch (3–10 mm) Rondelle; cylindrical vegetables cut to discs of desired thickness 1 ⁄ 8 – 1 ⁄ 2 inch (3–10 mm) Tourné; 2 inches (50 mm) long with seven faces usually with a bulge in the center portion; Mirepoix; 3 ⁄ 16 – 1 ⁄ 4 inch (5–7 mm)
Unified Thread Standard. The Unified Thread Standard ( UTS) defines a standard thread form and series—along with allowances, tolerances, and designations—for screw threads commonly used in the United States and Canada. It is the main standard for bolts, nuts, and a wide variety of other threaded fasteners used in these countries.